Frequently Asked Question

CH-100 Systems use the network Routers Dynamic Host Configuration Protocol (DHCP).

To Find the IP of your device we recommend using the advanced ip scanner (See link below)

or log into the local internet router and review the DHCP Client list:

Netgear: Attached Devices
Linksys:
TPLink: DHCP Client List
Verizon Router: Network>Client List

It is required that you set DHCP IP reservation in your network DHCP configuration.
(If you do not do so then any change in the network DHCP will disconnect AVLinkPro from your devices.)

LP-200, LP-360...Systems Connect eth0 (Single RJ45 Port*) on your ethernet network. You will need to find the system using an IP scanning tool

*The LP-360 model and RadPro models support 2 physical lan ports for advanced VLAN support.

*This tool is useful:
https://www.advanced-ip-scanner.com/

You will initially connect your device to a network with DHCP enabled and use an IP scanning tool to locate the AVLinkPro IP. 

Once you have identified the IP being used by the system

Open the following link with a browser
http://dhcp IP address:9090. Use the administrative login and password (Save it by checking the box)

Now go to network settings and change to  an IPV4 static IP and save the settings.